//
// CLS-222 Camera Link Simulator Configuration File
// - Factory preset #4 (mode switch positions 2&3 up)
//

//   Test Pattern Characteristics
//   - 1280x720 monochrome
//   - 8-bit pixel depth
//   - 10-tap
//   - 50 MHz pixel clock
//   - Diagonal wedge pattern
//   - Camera Link "80-bit" configuration


//
// *** Key Settings ***
// 

// Camera Link Mode 
// - 8-bit, 10-tap
CL_MODE     9

// Pixel clock frequency
// - 50 MHz
FREQUENCY   50

// Image Size
// - 1280 x 720
// - 10 pixels are sent every clock (10-tap)
// - LVAL_HI = X/taps = 1280/10 = 128
LVAL_HI     128
FVAL_HI     720

// Horizontal blanking
// - Configurator always sets to 32 clocks
LVAL_LO     32

// Vertical blanking
// - Configurator always sets to 16 clocks
FVAL_LO     16

// FVAL signal setup before LVAL
// - Configurator always sets to 8 clocks
FVAL_SETUP  8

// FVAL signal hold after LVAL
// - Configurator always sets to 8 clocks
FVAL_HOLD   8

// X dimension step setting
// - selects wedge pattern horizontal step size
// - 10 pixels sent every clock, so set to 10 for this example
X_STEP      10

// Y dimension step setting
// - selects wedge pattern vertical step size
// - 1 is typical setting 
Y_STEP      1

// Pattern Select
// - 10-taps "A-J" apply for this example
// - set all to diagonal wedge
A_PATSEL    3
B_PATSEL    3
C_PATSEL    3
D_PATSEL    3
E_PATSEL    3
F_PATSEL    3
G_PATSEL    3
H_PATSEL    3
I_PATSEL    3
J_PATSEL    3

// Wedge Pattern Initial Value
// - 10-taps "A-J" apply for this example
// - wedge pattern starting values increment for diagonal wedge
A_INIT      0
B_INIT      1
C_INIT      2
D_INIT      3
E_INIT      4
F_INIT      5
G_INIT      6
H_INIT      7
I_INIT      8
J_INIT      9


//
// *** Remaining Settings ***
// 

BAR_WIDTH   160     / automatically set by configurator, value does not matter
CONTINUOUS  1       / continuous video output
EXSYNC_ENB  0
EXSYNC_SEL  0
LINESCAN    0
DVAL_MODE   0
DVAL        1
CLK_DIS     0
BAYER_SEL   0
ROLL        0
A_FIXED     0
B_FIXED     0
C_FIXED     0
D_FIXED     0
E_FIXED     0
F_FIXED     0
G_FIXED     0
H_FIXED     0
I_FIXED     0
J_FIXED     0
AIA_TEST    0
AIA_SEL     0
POCL_MODE   0

// End of configuration file